+ Reply to Thread
Results 1 to 10 of 10
Photographers Lounge Thread, hi all, question about iso in BytePhoto Community; like i said before im extremely new to photography and wondering if someone has the patience to answer my questions.Okay...i'm ...
-
Apr 21st, 2008 10:28 AM #1
Junior Member
- Join Date
- Mar 2008
- Location
- las vegas
- Posts
- 10
hi all, question about iso
like i said before im extremely new to photography and wondering if someone has the patience to answer my questions.Okay...i'm using my close up mode ,my focal length is7.5-26.3 mm im using a 64 iso,im recently looking through these beautiful pictures and i noticed that hardly anyone uses a 64 setting and i see alot of 400 and 200 im i using the wrong iso and what the diffrence between 64 and lets say 200 or 400
-
Apr 21st, 2008 12:16 PM #2
Cory,
The lower ISO you can use the better. Most likely the shots you are referencing the photographer had to increase ISO for one reason or another. For instance, I have a shot in my gallery ( http://www.bytephoto.com/photopost/s...hp?photo=86897) of my daughter performing at her dance recital. Dark theatre with flash proscribed and I had no tripod. So I bumped the ISO to 400 so that I could handhold the shot. If I hadn't moved to 400 ISO my shutter speed would be much slower and I most likely would have had a shot that was blurry due to camera shake. There may be specific instances where one would rasie the iso to create a specific effect but that's the exception rather than the rule. ISO is a measure of sensitivity to light and the higher the ISO the more apt you are to see grain/noise in an image. Let me know if that fully answers your questions.
Darren
-
Apr 21st, 2008 12:54 PM #3
Junior Member
- Join Date
- Mar 2008
- Location
- las vegas
- Posts
- 10
thank you so much i really appreciate that.So basically the lower the iso the less noise and clearer picture and the higer the more noise because of the longer shutter speed
-
Apr 21st, 2008 02:16 PM #4skeuos Guest
Hi Cory,
You're mostly correct with that summary. Higher ISO has more noise because it has to boost the signal to allow for a shorter exposure time. This allows you to take a picture in lower light without using something to hold the camera steady. If you use a lower ISO, you'll need a longer exposure time for the same shot compared to a higher ISO, and thus you'll increase the chance of shaking the camera during the shot, resulting in a blurry shot.
It's similar to cranking up a speaker to hear it better - the signal becomes a little less clear as the intensity/volume increases because more noise is now discernible too.
A general rule of thumb is to use the lowest ISO you can. It's very easy to add noise (sometimes referred to as grain) artificially to a shot after you take it, but it's very difficult to remove noise and still have a clear shot. However, it's even more difficult (sometimes impossible) to sharpen a blurry shot that should have been done either with a tripod or at a higher ISO.
Hope that makes sense,
steve
-
Apr 21st, 2008 03:07 PM #5
Junior Member
- Join Date
- Mar 2008
- Location
- las vegas
- Posts
- 10
i think i get it ,if im in a room or outside with no tripod and low light i want to increase my iso so that my picture wont come out as blurry as opossed to using a low iso with no tripod.But if im in a room or outside with sufficiant lighting your best bet is to go with the low iso and tripod?correct? thanks again for being patient with me im kinda thick headed
-
Apr 21st, 2008 03:51 PM #6
Cory,
You've got the basic idea pretty much. Here is a link that explains ISO and noise. http://www.shortcourses.com/use/using2-2.html.
Darren
-
Apr 21st, 2008 09:07 PM #7
Bytephoto Supporter







- Join Date
- Nov 2005
- Location
- Bumpass, VA
- Posts
- 1,936
- Blog Entries
- 1
It is important to understand your camera settings completely to use it properly. There is a direct relationship between ISO/f-stops(exposure)/shutter speed. It can take some time to fully understand it so I won't go into it here. Check your manual or better yet, go to the library and get a few books.
You should also know how to control dof (depth of field). Only by understanding (and practicing) will you be able to reach your maximum potential. Good luck. --Rick
-
Apr 21st, 2008 09:26 PM #8
Junior Member
- Join Date
- Mar 2008
- Location
- las vegas
- Posts
- 10
punwit im having trouble opening the link that you provided for me.But im sure i can find something along those line....thanks again for heading me in the right direction
-
Oct 1st, 2008 08:45 PM #9
Junior Member
- Join Date
- Sep 2008
- Posts
- 3
thanks for tips
-
Jan 23rd, 2010 04:48 PM #10
Junior Member
- Join Date
- Nov 2008
- Location
- Colorado, USA
- Posts
- 7
I don't know. I think there is a time and a place for everything. Sometimes I like the feel of high iso photos. For example the photos in this link were taken at a fashion show without a flash, but with iso 640 or something like that. I like the kind of grainy feel to them.
http://biascuts.com/2009/12/28/lina-chen-design-photos/http://biascuts.com
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
A question
By HRow in forum News and InformationReplies: 2Last Post: Jan 14th, 2010, 03:43 PM -
E-500 LCD Question
By danbee46 in forum OlympusReplies: 3Last Post: Aug 6th, 2006, 07:28 PM -
a question
By cristobal in forum Photographers LoungeReplies: 0Last Post: Oct 31st, 2005, 05:10 PM -
I have a question...
By Duniel in forum SonyReplies: 2Last Post: Apr 22nd, 2005, 04:44 PM




LinkBack URL
About LinkBacks



Reply With Quote




Bookmarks